QuoteWrite a program to read in a series of integers and print out only the odd numbers over 1000. At the end the program should also print out how many such numbers were found.
It's a hell of a lot easier than the assembler problem..
i have this so far:
in x
While
if x>1000 then load y
SET x=y/2
If x=1 then Add 1 to counter
End While
Print X
Print Counter
Halt
Basically if the numbers going to be odd and I continue to divide by 2, I should get a 1. If that's the case and the numbers over 1000 then it adds 1 to the counter.
How do I get it to say x=x/2
until it reaches 0 or 1?
EDIT: i fixed it. just tell me if its right or not